EZmake-it Blog

Ok,  I think I am going to order the PCB’s through Batch PCB  The cost will be $49.  It is only 1 oz copper and I should probably use 2 oz.  But inorder to save some $$ I am going to risk it.

I still need to develop the firmware; but it will go alot easier with the PCB in hand.

Power Drive Schematics

powerdrive gerbers

Stay Tuned!

This entry was posted on Tuesday, January 5th, 2010 at 04:52 and is filed under Electronic Speed Controller, electric mountainboard. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.